diff --git a/usbdrv/usbconfig.h b/usbdrv/usbconfig.h
index 106c4d7..a02b6ca 100644
--- a/usbdrv/usbconfig.h
+++ b/usbdrv/usbconfig.h
@@ -27,11 +27,11 @@ section at the end of this file).
 /* This is the port where the USB bus is connected. When you configure it to
  * "B", the registers PORTB, PINB and DDRB will be used.
  */
-#define USB_CFG_DMINUS_BIT      4
+#define USB_CFG_DMINUS_BIT      3
 /* This is the bit number in USB_CFG_IOPORT where the USB D- line is connected.
  * This may be any bit in the port.
  */
-#define USB_CFG_DPLUS_BIT       3
+#define USB_CFG_DPLUS_BIT       4
 /* This is the bit number in USB_CFG_IOPORT where the USB D+ line is connected.
  * This may be any bit in the port. Please note that D+ must also be connected
  * to interrupt pin INT0! [You can also use other interrupts, see section
@@ -107,7 +107,7 @@ section at the end of this file).
  * (e.g. HID), but never want to send any data. This option saves a couple
  * of bytes in flash memory and the transmit buffers in RAM.
  */
-#define USB_CFG_INTR_POLL_INTERVAL      100
+#define USB_CFG_INTR_POLL_INTERVAL      10
 /* If you compile a version with endpoint 1 (interrupt-in), this is the poll
  * interval. The value is in milliseconds and must not be less than 10 ms for
  * low speed devices.
@@ -116,7 +116,7 @@ section at the end of this file).
 /* Define this to 1 if the device has its own power supply. Set it to 0 if the
  * device is powered from the USB bus.
  */
-#define USB_CFG_MAX_BUS_POWER           20
+#define USB_CFG_MAX_BUS_POWER           100
 /* Set this variable to the maximum USB bus power consumption of your device.
  * The value is in milliamperes. [It will be divided by two since USB
  * communicates power requirements in units of 2 mA.]
@@ -374,5 +374,13 @@ extern void hadUsbReset(void); // define the function for usbdrv.c
 /* #define USB_INTR_PENDING        GIFR */
 /* #define USB_INTR_PENDING_BIT    INTF0 */
 /* #define USB_INTR_VECTOR         INT0_vect */
+#define USB_INTR_CFG            PCMSK
+#define USB_INTR_CFG_SET        (1 << USB_CFG_DPLUS_BIT)
+#define USB_INTR_CFG_CLR        0
+#define USB_INTR_ENABLE         GIMSK
+#define USB_INTR_ENABLE_BIT     PCIE
+#define USB_INTR_PENDING        GIFR
+#define USB_INTR_PENDING_BIT    PCIF
+#define USB_INTR_VECTOR         PCINT0_vect
 
 #endif /* __usbconfig_h_included__ */